diff --git a/ws2812_controller.ino b/ws2812_controller.ino
deleted file mode 100644
index 0316838..0000000
--- a/ws2812_controller.ino
+++ /dev/null
@@ -1,79 +0,0 @@
-#include <Arduino.h>
-#include <ESP8266WiFi.h>
-//#include <WebSocketsServer.h>
-//#include <Hash.h>
-#include <WiFiUdp.h>
-#include <NeoPixelBus.h>
-
-// Set to the number of LEDs in your LED strip
-#define NUM_LEDS 242
-// Maximum number of packets to hold in the buffer. Don't change this.
-#define BUFFER_LEN 726
-// Toggles FPS output (1 = print FPS over serial, 0 = disable output)
-#define PRINT_FPS 1
-
-//NeoPixelBus settings
-const uint8_t PixelPin = 3;  // make sure to set this to the correct pin, ignored for Esp8266(set to 3 by default for DMA)
-
-// Wifi and socket settings
-const char* ssid     = "ASUS_VIVOBOOK";
-const char* password = "T!PT)Psecret";
-unsigned int localPort = 7778;
-byte packetBuffer[BUFFER_LEN];
-RgbColor ledDataBuffer[NUM_LEDS];
-
-// LED strip
-NeoPixelBus<NeoGrbFeature, Neo800KbpsMethod> ledstrip(NUM_LEDS, PixelPin);
-
-WiFiUDP port;
-
-// Network information
-// IP must match the IP in config.py
-IPAddress ip(192, 168, 137, 200);
-// Set gateway to your router's gateway
-IPAddress gateway(192, 168, 137, 1);
-IPAddress subnet(255, 255, 255, 0);
-
-void setup() {
-    Serial.begin(115200);
-    //WiFi.config(ip, gateway, subnet);
-    WiFi.mode(WIFI_STA);
-    WiFi.begin(ssid, password);
-    Serial.println("");
-    // Connect to wifi and print the IP address over serial
-    while (WiFi.status() != WL_CONNECTED) {
-        delay(500);
-        Serial.print(".");
-    }
-    Serial.println("");
-    Serial.print("Connected to ");
-    Serial.println(ssid);
-    Serial.print("IP address: ");
-    Serial.println(WiFi.localIP());
-    port.begin(localPort);
-    ledstrip.Begin();//Begin output
-    ledstrip.Show();//Clear the strip for use
-}
-
-uint8_t N = 0;
-#if PRINT_FPS
-    uint16_t fpsCounter = 0;
-    uint32_t secondTimer = 0;
-#endif
-
-void loop() {
-    // Read data over socket
-    int packetSize = port.parsePacket();
-    // If packets have been received, interpret the command
-    if (packetSize) {
-        int len = port.read(packetBuffer, BUFFER_LEN);
-        for(int i = 0; i < len; i+=4) {
-            packetBuffer[len] = 0;
-            N = packetBuffer[i];
-            RgbColor pixel((uint8_t)packetBuffer[i+1], (uint8_t)packetBuffer[i+2], (uint8_t)packetBuffer[i+3]);
-            ledstrip.SetPixelColor(N, pixel);
-        }
-        ledstrip.Show();
-        Serial.print("/");
-    }
-}